Christie Roadie HD+35K, User Manual

Page: 75 / 192

Section 3: Operation
Roadie HD+35K User Manual 3-9
020-100340-02 Rev. 1 (01-2010)
3.2.5 Guide to Keypads
Keep in mind the following guidelines:
• Press keys one-at-a-time; there are no simultaneous key combinations available.
• To protect against accidental use, there are three keys (Power, Shutter, and OSD) which are "press-and-hold"
keys that do not function with a typical quick press-and-release keypress.
• Press and hold the
A
RROW keys down for continuous adjustment/movement in the desired direction. In serial
networks, pause briefly between adjustments to ensure that more distant projectors can "keep up" with the
commands.
• If you press a key while the projector is still responding to the previous action, such as during power-up, the
second key press may not take effect.
3.2.6 Keypad and Standard IR Remote Functions
Specific keys related to the built-in keypad and standard IR remote perform various functions as explained
below.
Power (ON/OFF) Key
Using either the built-in keypad or standard IR remote, do one of the following to switch the projector ON or
OFF, and ignite the lamp:
• press and hold the
P
OWER
key for at least two seconds
• press the
P
OWER key and then press the
U
P or
D
OWN Arrow keys on either the built-in keypad and
standard IR remote (useful if you are unsure of the present state of the projector)
• press the
P
OWER
key twice quickly to toggle from the projector’s present ON/OFF state
The main
PROJ. STATUS
light at the rear of the projector should now be green on the projector to indicate that
the projector is up-and-running. For best results, let the projector warm up for about 5 minutes.
NOTES: 1) After powering down, the lamp cooling fan remains ON for approximately 10 minutes to cool the lamp.
2)
It is a good idea to avoid turning a projector back ON until it has been OFF for at least 2-3 minutes.
Hot re-strikes of the lamp may reduce lamp life.
Test Function Key
Press the
T
EST key on the standard IR remote to scroll through the projector's internal test patterns, in order,
including the current input. To scroll through the test patterns (no input) only, use the
L
EFT
/R
IGHT
Arrow keys
to move in either direction.
Auto (Setup) Function Key
Press the
A
UTO key on the standard IR remote or
A
UTO
S
ETUP on built-in keypad to initiate an automated
process which allows the projector to optimize critical display parameters, such as size, position, pixel
tracking, etc., for the current Input source. These parameters are listed in
Table 3.3 . The Auto Setup function
can save time in perfecting a display, and allow you to make adjustments as desired.
Table 3.3 Auto Setup
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Pixel Tracking Contrast
Pixel Phase Brightness