2-48
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 2: Installation and Setup
2.14.1 Standard IR Remote Protocols
The
Roadie HD+35K's
standard IR remote can be set to 1 of 7 different protocols (A through G).
To change protocol in the remote, follow Steps 1 through 4:
1. Unlatch and open the battery compartment on the back of the remote as shown in
Figure 2-54
.
Figure 2-54 Opening the Remote
2. Find the 4 jumpers located along the latching side of the battery compartment. These jumper settings
establish the remote’s protocol so that the remote functions in a certain manner.
3. Set the jumpers to match one of the protocols shown in
Figure 2-55
. Use tweezers or needle-nose pliers to
remove and replace each jumper as necessary.
•
J1
jumper - Set between 1 and 2 or 2 and 3 as required for the desired protocol.
•
J2
jumper - Set between 1 and 2 or 2 and 3 as required for the desired protocol.
•
J3
jumper - Set between 1 and 2 or 2 and 3 as required for the desired protocol.
•
J4
jumper - For IR use, always set between pins 1 and 2 (see A-G below).
Figure 2-55 Locating and Setting the Jumpers
4. Replace the battery compartment cover. To test, plug wired IR remote into the projector.
NOTE:
If you change any remote to a new protocol and the projector stops responding, the projector may be set to
a conflicting protocol. Use the projector's built-in keypad to access the Communications secondary menu.
Under "Front IR" or "Back IR", select the protocol that matches the new protocol of the remote at hand.
The projector should now respond properly.
Roadie 35K Standard IR Remote
Summary of Contents for Roadie HD+35K
