![background image](http://html.mh-extra.com/html/christie/roadie-hd-35k/roadie-hd-35k_user-manual_2604044130.webp)
3-64
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 3: Operation
Figure 3-37 Setting LampLOC
How to Adjust (if using a light meter)
. Obtain peak readings on a light meter at the center of the screen. For
each axis, adjust in one direction, and then back up when the reading begins decreasing.
NOTES: 1)
Display a 100% white internal test pattern.
2)
Use a tripod to center the light meter with the lens.
Distance from the lens does not matter. You may need an attenuator, or wish to construct an internal foil
aperture first.
3)
This is an optional procedure-watch the intensity feedback shown near the top of the
menu if preferred.
1. Adjust forward/aft (z) until the brightness reading in front of the lens is maximized.
2. Adjust left/right (x) and up/down (y) until the brightness reading in front of the lens is maximized
3. Re-adjust forward/aft (z) as necessary.
4. Repeat Steps 1-3 as necessary.
5. Reset
Lamp Power
or
Intensity
, if desired.
3.10.7 Stand-by Mode
Close the internal
S
HUTTER
to blank the image and put the projector in a cooler stand-by mode with minimum
power going to the lamp. Lamp power is reduced to 60% of the maximum rating for 4.5 and 6.0 kW lamps, or
75% of the maximum rating for 2.0 and 3.0 kW lamps. Upon opening the shutter and restoring the image, the
lamp power returns to its previous setting.
Summary of Contents for Roadie HD+35K
