Christie Roadie HD+35K, User Manual

Page: 44 / 192

2-28 Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 2: Installation and Setup
2.5.5 Extra Video
If you want to use an extra video source in
addition to the video source(s) connected at
INPUT 3 or INPUT 4 connect either a
Composite or S-video source to INPUT 1 as
shown.
NOTES
:
1)
Do not simultaneously connect
Composite and S-video to INPUT 1.
2)
You can switch between video sources
connected at INPUT 1 and INPUT 3 or
INPUT 4.
2.5.6 Optional Inputs
Optional Input modules allow you to increase
your total number of inputs and/or accommodate
different signal types, whether analog or digital.
Install in the areas labeled
INPUT 6 or (if
available) INPUT 5 . These interfaces include:
• DVI Input Module
• Dual SD/HD-SDI Module (supplied as stan-
dard in this projector)
For even more sources, connect a third-party
switcher to the RS-232 IN port, or, if RS-422-
compatible, to any of the two RS-422 ports.
Older Input cards not listed may be supported by
the Roadie HD+35K.
NOTES: 1)
Connect analog HDTV signals directly
to INPUT 1 or to any other "RBG" Input
module installed-the optional HDTV Input
Module used in earlier projectors is not
needed or recommended.
2)
See
Section 2
Installation and Setup
for a brief description of each interface.
2.6 Connecting Communications
As an alternative to the projector's built-in keypad or standard IR remote, you may wish to communicate with
the projector using a PC or other controller. Such a device sends commands and receives feedback via serial
links (two types), Ethernet or GPIO communications, all described below.
Input 5
(Opt. 1)
Input 6
(Opt. 2)
Ethernet
Input 4
S-Video
Input 3
Video
Input 2
DVI
RS422
RS232
IN
GPIO
OUT
RS232
Remote
Input 1
Red
Green
Blue
Hor /
Comp
Vert
Sync
From
Composite
Video
Source
AC
TI
V
E
SI
G
N
AL
FR
OM
Du
al
S
D
HD
-S
DI
38
-8
046
56
A
A B
C
BD
IN
P
U
T
OUTP
UT
OUTP
UT
From S-Video
Source
CONNECT COMPOSITE
OR S-VIDEO TO
INPUT 1 - NOT BOTH
Figure 2-31 Connect Extra Video