Christie Roadie HD+35K, User Manual

Page: 124 / 192

3-58 Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 3: Operation
Figure 3-33 Checking/Setting Lamp Size
NOTES: 1) Setting the lamp size requires a
Christie accredited service technician.
The required password for access is a
service option that may be turned off.
2)
Current lamp size should also be
recorded on the "Lamp Installed" label
located on the lamp door-see right.
Mark the appropriate lamp size using a
small blue dot label (see inside cover of
this manual), or mark with a dry-erase
pen.
If the projector is already running, consult the
Status
menu to see which lamp size is currently recorded in
projector's memory. If this does not match the installed lamp, you can either change the Lamp Size setting in
the service password-protected
Service
menu, which implements the new size at the next power-up, or you can
power down and press
M
ENU
to use the LCD for lamp selection, as described above (passwords are shown in
Figure 3-34 . Always indicate current lamp size on the
Lamp Installed
label.
3.10.2 Lamp Cable Lengths
The high-voltage DC cables connected between the lamp ballast and the rear of the projection head can be 2-30
meters in length, depending on your site requirements and setup. The length currently in use must be defined in
projector software for any new installation. This setting compensates for the voltage drop that occurs over
distance and ensures that the proper voltage is maintained at the lamp. In the
Lamp
menu, set the "Cable
Length (m)" slidebar to match that of your DC cables. By default from the manufacturer, this setting is 8
(approximately 25 feet). See
Figure 3-35 .
,DMT
Press “Menu” before power up.
Screen below displays lamp size.
1.
3.
Or standard Christie service password.
2.
D
Lamp Size
6000
Select installed lamp size:
2000
3000
4500
6000
on the
standard
IR remote
on built-in
keypad
or
HOW TO SET THE LAMP SIZE:
on the
standard
IR remote
or
Enter Lamp Password:
on built-in
keypad
D
(MOTSỻ (MOTSỻ (MOTSỻ (MOTSỻ
7
4
1 0
Figure 3-34 Use the “Lamp Installed Label