Section 4: Maintenance
Roadie HD+35K User Manual
4-5
020-100340-02 Rev. 1 (01-2010)
If Fingerprints, Smudges, Oil:
1. First brush dust off with a camelhair brush and/or blow dust away with compressed air.
2. Fold a clean microfibre cloth and dampen with methanol. Make sure to wipe evenly with the smooth
portion of the cloth that has no folds or creases. Do not apply pressure with your fingers. Instead, use the
tension in the folded cloth itself to collect the dust.
4.3.3 Other Components
In a normal operating environment check, clean and treat the following components every 6 months or so to
help ensure proper lamp and projector function:
Igniter
Clean the high voltage terminal and insulator to remove accumulated dust or dirt.
Air Flow Interlocks
The lamp fan vane switch is located within the lamp-cooling compartment. The extractor vane switch is
located just inside the top duct on the projector lid. Check and, if necessary, clean the switches to remove
accumulated dust or dirt that could impede movement. Within the exhaust hood connected at the top of the
projector, adequate airflow must be maintained and routed away from the operating area surrounding the
projector (or any nearby projectors). Inspect regularly and confirm that all air intake areas of the projection
head and ballast are unobstructed.
4.4
Replacing the Lamp & Filter
The high brightness of your projector is provided by a Xenon lamp mounted at two ends within a reflector and
housed in the locked lamp compartment of the projection head. When the lamp approaches the end of its life, it
must be replaced-do not exceed warranted lamp life by more than 20%, as an old lamp becomes increasingly
and dangerously fragile, resulting in possible explosion.
To determine the age of your current lamp, consult the
Status
menu or
Lamp
menu.
It is recommended that you replace the air filter with every lamp replacement, or sooner in dusty or dirty
environments. Check its condition monthly in all projectors.
4.4.1 Lamp Replacement Procedure
NOTE:
For this procedure, you need a compatible Christie Xenon CDXL or CXL lamp as shown in
Section 6
Specifications
. NEVER install a lamp intended for a different projector.
Make sure to use the correct wattage lamp supplied by Christie.
Lamp replacement is to be done by a Christie accredited service technician only.
Explosion Hazard
. Wear authorized protective clothing whenever the lamp door is open!
Never apply a twisting or bending force to the quartz lamp body.
Read and follow all other general lamp precautions in
4.1, Warnings and Guidelines
.
1. By pressing and holding the
P
OWER
button (any remote or keypad), turn OFF the projector.
2. Once OFF, allow the fans to run at least 10 minutes for cooling the lamp.
Summary of Contents for Roadie HD+35K
