Section 2: Installation and Setup
Roadie HD+35K User Manual
2-35
020-100340-02 Rev. 1 (01-2010)
Figure 2-39 Typical Ethernet Network
Setting the Projector’s IP Address
Upon connection to most Ethernet networks, each projector's factory default IP address of 0.0.0.0 triggers the
network's DHCP (Dynamic Host Configuration Protocol) server to automatically assign an IP address that is
valid and unique for use on that network. Depending on the network, this DHCP-assigned IP address usually
remains stable for the current session, but may change with subsequent power-ups, and log ins. On some
networks, the address even remains stable from session to session. In all cases, the projector's IP address and
port appear in the
Status
menu, as well as, the
Ethernet Settings
secondary menu.
Figure 2-40 Setting the Projector's IP Address
It should be noted that if a networked projector's IP address is anything other than the default of 0.0.0.0 (shown
as 000.000.000.000 in the
Ethernet Settings
menu), or if a DHCP server is not available, the automatic DHCP
server function for supplying a valid and unique IP address is disabled. Instead, you must define a specific and
static IP address by entering the new address in the
Ethernet Settings
secondary menu, or by sending one to
the projector via a serial command. The projector then responds to commands sent to this address after the next
power-up, after which the IP address remains in projector memory until you enter a new one, or until the
DHCP check box is selected.
Use Ethernet cables to
connect to all Ethernet
devices
Summary of Contents for Roadie HD+35K
