Christie Roadie HD+35K, User Manual

Page: 20 / 192

2-4 Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 2: Installation and Setup
Figure 2-4 Connect Head to AC
Do not attempt operation if the AC level is not within the specified voltage, and
power range for the projection head.
At this point, the projection head is in a type of "standby" mode only. The voltmeter should display the
incoming voltage, the adjacent main PROJ. STATUS light should be yellow, and the light engine
compartment fans running, but the rest of the projection head should be OFF.
5. Set the lamp type.
EXPLOSION HAZARD. Keep the projection head OFF until you have defined which
lamp type is installed.
Before switching the projector ON and igniting the lamp, you must define in memory which size lamp is
installed; otherwise, you risk severely over driving or under driving a lamp.
NOTE:
Ensure that you record the lamp size on the "Lamp Installed" label.
a. Press
M
ENU . The Status Display at the rear of the projector shows a "Lamp Size" of 2000, 3000, 4500
or 6000 watts, depending on its last setting. The Factory default is 6000 watts.
b. Enter either the Lamp Password. Refer to Figure 2-5 .
NOTE:
The password is required unless the "Enable Password" service option has been turned OFF.
Projector Rear
To AC
200-240 VAC