Christie Roadie HD+35K, User Manual

Page: 76 / 192

3-10 Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 3: Operation
NOTE: You must have an unlocked channel present to use
A
UTO
S
ETUP
.
Help Function Key
Press the
H
ELP
key (either the built-in keypad and standard IR remote) to display summary information about
the current menu or highlighted menu option. Or, if there is no menu present, press
H
ELP
to access a list of
general Help topics. To exit any Help text display, press the
H
ELP
key again or press
EXIT
.
Channel Selection Key
Press the
C
HAN
key to select a specific source setup (channel) already defined and stored in the projector’s
memory. Once you enter a 2-digit channel number (or, if there is a list available, highlight the Channel option,
and press
ENTER)
, the display automatically changes and updates according to the numerous setup parameters
defined for the selected channel. Understand that a new channel is automatically created if you adjust an image
from a new source.
NOTE:
The
C
HAN
key behavior during a presentation depends on whether or not the
Display Channel List
option is enabled in the
Menu Preferences
menu. You can choose to use a scrollable list of channels
when you press the
C
HAN
key, or you may prefer to enter the desired Channel number "blind", i.e., without
on-screen feedback. Refer to
Menu Preferences
later in this section.
Input 1 Key (BNC)
Press the
I
NPUT
1
key to display from the data input source connected to BNCs labeled INPUT 1 . If PIP is
enabled, press INPUT 1 to assign it as the PIP source. This option is not available with some models.
Input 2 Key (DVI)
Press the
I
NPUT
2
key to display from the DVI source (analog or digital) connected to INPUT 2 . If PIP is
enabled, press INPUT 2 to assign it as the PIP source.
Input 3 Key (VID)
Press the
I
NPUT
3
key to display from the composite video source connected to INPUT 3 . If PIP is enabled,
press INPUT 3 to assign it as the PIP source. This option is not available with some models.
Input 4 Key (S-VID)
Press the
I
NPUT
4
key to display from the S-video source connected to INPUT 4 . If PIP is enabled, press
INPUT 4 to assign it as the PIP source. This option is not available with some models.
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Size and Blanking Auto Input Level (off)
Vertical Stretch Detail (if video source)
Position Filter
Input Levels Luma Delay
Table 3.3 Auto Setup