Transmission Centaur Service Manual
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
TR-66
5. Install the rubber oil seal to the output sprocket using a soft faced hammer and install
-
ing tool.
Photo TR-358
6. Install the brake disc using 4 M6 hex head bolts and lock washers. Apply blue 242
LOCTITE to each thread and torque to specifications.
Photo TR-359
Be careful not to damage the rubber oil seal in any way. Any deformity to it could af-
fect the sealing edge, the result being a possible oil leak.
TR-358
TR-357
TR-359
TR-360
If your CENTAUR is equipped with the steering lock system, do not install the hydrostatic
pump to the vehicle at this time. Wait until the transmission has been mounted securely
back into the vehicle. Otherwise proceed with the following:
7. Place a new “O” ring to the pump and install the pump to the transmission by aligning
the spline shaft of the pump with that of the internal spline within the transmission.
Photo 360 & 361
Summary of Contents for 2001 950
