Brake System Centaur Service Manual
BR-34
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
BR-34
Photo BR-69 &70
illustrate the routing of the steel brake line from the front master cylinder
to the rear caliper. The steel line is in 2 sections with 1 union at the master cylinder and
1 close to the Upper Frame - Cross Frame Assembly
.
The numbers indicate the fastening
points along the length of the steel line.
Replacing the Hydraulic Brake Line
1. Perform the servicing procedure,
Inspecting the Hydraulic Brake Line
on page BR-
34
2. Perform the servicing procedure,
Changing the Brake Fluid
Steps 1 through 3 on
page BR-36
BR-69
BR-70
3. Undo the shifter assembly to the drivers
left hand side. This is secured with 3
bolts. 2 bolts are fastened into the upper
frame by 2 8mm inserts. The other is
secured to the dash with a bolt, locknut,
and a flat washer on each side of the bolt.
Photo BR-71
4. Leaving all linkage attached, move the
shifting assembly out of the way to access
the brake lines mounting bracket bolts.
5. Remove the bracket bolts fastening the section of line to be replaced
BR-71
6. Replace the brake line, replenish the brake fluid system and perform the servicing
procedure,
Bleeding the Hydraulic Brake System
on page BR-25
Summary of Contents for 2001 950
