Steering System
Centaur Service Manual
Ontario Drive & Gear Limited www.centaur8x8.ca
(519) 662-2840 FAX (519) 662-2421
ST-12
ST-12
17. Install the steering wheel next and orient as shown in
Photo ST-27
18. Refering to the CENTAUR Parts Manual, install the required locknut to fasten the
steering wheel to the threaded end of the shaft.
19. Attach the adjuster assembly plate to the column using 1 bolt, 2 flatwashers and 1
locknut.
Photo ST-28
20. Attach the adjuster plate to the lower adjuster assembly using 1 ”C” bolt and securing
it with a star knob.
Photo ST-29
Do not over tighten. Tighten only until all play is removed. Install the steering wheel
cover.
21. Fasten the steering column to the ROP using 2 bolts, 4 washers, 2 nylon washers and
2 locknuts. Refer to your CENTAUR parts manual for the specified hardware.
Photo
ST-30, 31 & 32
ST-27
ST-28
ST-29
ST-27
16. If the spring pin was removed from the steering tube during disassembly, install it into
the hole drilled at the end of the tube. Make sure the pin protrudes from the hole about
1/8”, pointing upwards to the top of the steering column.
Photo ST-26
ST-26
Summary of Contents for 2001 950
