Canon iR7086, Service Manual

Page: 86 / 735

Chapter 2
2-28
F-2-108
12) Route the control panel interface cable [2] through the hole in the arm
cover [1].
13) Keep the control panel interface cable along the cable guide [3], and fit
it in the groove of the arm cover.
14) While hooking the claw [4] of the arm cover on the cut-off [5] of the arm
unit, put the arm cover over it.
F-2-109
15) Remove the screw [1], and detach the rear support cover [3] of the con-
trol panel unit [2].
F-2-110
16) Fit the control panel unit [1] in place to the arm unit.
- 1 flat-head screw (M4X10) [2]
- 1 screw (W sems; M4X12) [3]
F-2-111
17) Fit the rear support cover [2] removed in step 16) to the control panel [1]
using the screw [3] removed also in the same step.
F-2-112
18) Fix the arm cover [1] in place.
- 2 screw (P tightening; M4X10) [2]
F-2-113
19) Mount the arm lower cover [1].
- 1 screw (binding; M4X10) [4],
Match the wire saddle at the rear and the marking [3].
Be sure that the cable guide [3] is oriented so that the side with a protrusion
(thicker end) is downward.
Note that the cable guide [3] divides itself into two during the work. The fact
will not affect its function, and the work may be continued.
[1]
[2]
[3]
[3]
[2]
[4]
[5]
[1]
[1]
[2]
[3]
[3]
[2]
[1]
[3]
[2]
[1]
[2]
[1]