Canon iR7086, Service Manual

Page: 487 / 735

Chapter 13
13-5
13.3.2 Scheduled Servicing Chart
0010-9512
iR7105 / iR7095 / iR7086
Do not use solvents other than those indicated.
T-13-5
11 Clean the fixing/delivery assembly.
- separation claw (upper, lower)
- transport rollers
- inlet guide
- web (check)
- web oil receptacle
- thermistor
- sub thermistor
- thermal switch
12 Clean the cleaner assembly.
- side scraper
13 Clean the duplexing assembly.
- duplexing horizontal registration sensor
14 Clean the copyboard glass.
15 Make test prints.
16 Make sample prints.
17 Press the leakage breaker test switch to see the breaker
operates normally. Thereafter, turn off the power switch,
and shift the lever to ON position; then, turn the power
switch back on. Press the test switch while the power switch is in ON
position and, in addition, the lever [1] of the leakage
breaker is also in ON position. If normal, the breaker
will go off to cut the power. (If you are replacing it,
pay attention to its orientation.)
If you have replaced the leakage breaker, be sure to
check the breaker after replacement.
Check to see that the grounding is proper. Otherwise, the leakage breaker may fail to go on in the event of a leak.
18 Put sample prints in order, and clean up the area around
the machine.
19 Record the most recent counter reading.
20 Update the service book, and report to the person in
charge. Record the history of checks made on the leakage
breaker.
Unit name Location Maintenance intervals Remarks
upon installation every 500,000
prints every 1,000,000
prints
Externals/controls copyboard glass clean
ozone filter
(FM2, FM8, FM20) clean replace Remove the dust from the filter surface.
No. Step Work Remarks
[1]