Canon iR7086, Service Manual

Page: 74 / 735

Chapter 2
2-16
F-2-40
2) Remove the fixing [1] (1 screw [2]), and disconnect the connector [3].
F-2-41
3) While holding the front side of the transfer separation charging assembly
[1] and A part, pull it out approx 1 cm, and then detach it in upper left di-
rection.
Clean the transfer separation charging wire using alcohol.
F-2-42
4) Mount the transfer separation charging assembly [1] while keeping the
following in mind:
- all solvent must be fully dry.
- the gut wire must not be in contact with the transfer guide [2] to avoid a
cut.
- the grounding plate [3] must be outside the charging assembly frame[4].
F-2-43
5) Connect the connector of the transfer separation charging assembly, and
fit the fixing in place.
6) Attach the transfer separation charging assembly front cover.
7) Return the fixing feed unit inside the device and return the fixing feed unit
release lever [1] in the original place.
F-2-44
8) Remove the primary charging assembly front cover [1].
- screw [2]
F-2-45
9) Disconnect the connector [1] and press the primary charging assembly
lock lever [2] to release it, and then remove the primary charging assem-
bly [3].
Clean the primary charging wire and the grid wire using alcohol.
[1]
[2]
[1]
[2]
[3]
[1]
[2]
[1]
[2]
[1]
[2]
[1]