Canon iR7086, Service Manual

Page: 637 / 735

Chapter 17
17-49
<PANEL>
T-17-39
<Input Key Names and Screen Indications>
<PART-CHK>
T-17-40
COPIER > FUNCTION > PANEL
Sub item Description Level
LCD-CHK Use it to check for missing dots.
1
<Procedure>
1) Select the item, and press the OK key so that the LCD will go on in the following sequence: white, black, red, green, blue.
2) Press the stop key to stop the operation.
LED-CHK Use it to check the activation of the LEDs on the control panel.
1
Use it to check the activation of the LEDs on the control panel.
1) Select the item, and press the OK key so that the LEDs will go on in sequence.
2) Select LED-OFF to stop the operation.
LED-OFF Use it to check the activation of the LEDs on the control panel (to stop).
1
<Procedure>
1) Select the item to stop LED-CHK operation.
KEY-CHK Use it to check key inputs.
1
<Procedure>
1) Select the item so that the number/name of a specific input key appears.
2) Press a key to check. If normal, the corresponding character will appear on the LCD. (See the table.)
3) Select the item once again to stop the operation.
TOUCHCHK Use it to adjust the coordinates of the LCD.
1
Execute this item if you have replaced the control panel so that specific points on the LCD will match specific coordinates.
<Procedure>
1) Select the item, and press the OK key.
2) Press the 9 +s that appear in sequence on the LCD.
Key Indications Key Indications Key Indications
0 to 9,#,* 0 to 9,#,* Initial Setup/Register USER Authenticate ID
Reset RESET Start START Help ?
Stop STOP Clear CLEAR Check Counter BILL
COPIER > FUNCTION > PART-CHK
Sub item Description Level
CL Use it to specify the clutch whose operation you want to check. (settings: 1 to 21)
1
<Procedure>
1) Select the item.
2) Type in the appropriate number using the keypad.
3) Press the OK key.
CL-ON Use it to start a check on the operation of a clutch.
1
<Procedure>
1) Select the item, and press the OK key so that the clutch repeatedly goes on and off as follows:
on for 05 sec -> off for 10 sec -> on for 0.5 sec -> off for 10 sec -> on for 0.5 speed -> off
MTR Use it to select a motor whose operation you want to check. (settings: 1 to 13)
1
<Procedure>
1) Select the item.
2) Type in the appropriate number using the keypad.
3) Press the OK key.
MTR-ON Use it to start a check on the operation of a motor.
1
<Procedure>
1) Select the item, and press the OK key.
- on for 20 sec -> off
- if buffer motor or duplexing horizontal registration motor, on for 10 sec -> off
- if shift tray motor, stops at front/rear HP
- if vibration motor (M10/M20), repeats on and off at intervals of about 5 sec
SL Use it to select the operation of a solenoid.
1
<Procedure>
1) Select the item.
2) Enter the appropriate number using the keypad.
3) Press the OK key.
SL-ON Use it to start a check on the operation of a solenoid.
1
<Procedure>
1) Select the item, and press the OK key.
on for 0.5 sec -> off for 5 sec -> on for 0.5 sec -> off for 5 sec, on for 0.5 sec -> of