Canon iR7086, Service Manual

Page: 457 / 735

Chapter 11
11-37
F-11-57
3) When you click Initialize button, the confirmation message appears. Click OK button. Then Login page opens. Enter the default password 'MeapSmsLogin' to
log in. The password is case-sensitive.
If you click Cancel button, the Login page opens without initializing the password.
11.1.25 Creating a Backup for MEAP Application Area, Formatting the Hard Disk, Restoring the MEAP Application Area with
the Backup, Using the SST (Service Support Tool)
0017-9711
iR7105 / iR7095 / iR7086 / iR7095P
You can back up the area of the HDD where MEAP applications reside to a PC, as when you want to format the HDD. MEAP devices use a license-based mechanism
to control applications so that formatting the HDD will necessarily delete the jar files and application data, requiring you to not only reinstall them but also make
necessary settings. (Doing so consists in obtaining special license files for reinstallation and downloading user data/settings, increasing your work load.)
If you use the SST's backup function, you will be able to temporarily put aside the area of MEAP applications, thus being free of the foregoing extra work. This
function, however, is limited to a specific MEAP device (serial number), and cannot be used for illegal copying of applications.
You must not perform any other work (including checking operation) until the HDD has been backed up. This arrangement is to prevent a mismatch of MEAP
counter readings and the HDD contents, and any fault in operation arising as the result of failure to observe this will not be covered by the guarantee of operation.
Memo:
The application that is installed with a reusable license can be reinstalled by using the same license.
The following list shows the details of area that SST backs up;
Jar files of MEAP applications
Settings set with MEAP applications.
Note that SST does not back up images in Mailboxes that MEAP applications use.
User information data registered with SDL
Requirements for Backup Using the SST
The following conditions must be met for use of the function:
1) Device Firmware Version
T-11-18
2) SST Version
Version 1.81 or later. An earlier version will not permit the use of the function. If needed, upgrade the SST.
3) Space for backup
To back up the HDD of the iR, the PC must have approx 300 MB of free space at maximum.
Boot ROM System SST
iR2220 Series
iR2250 Series 24.42 later 33.01 later Since Ver 1.81
iR5020 Series
iR5160 Series 24.42 later 54.02 later Since Ver 1.81
Devices ither than those listed the above. Already supported since the 1st version. Already supported since the 1st version. The version supporting the
corresponding devices.