Canon iR7086, Service Manual

Page: 132 / 735

Chapter 2
2-74
2.9.2 Installing to the paper Deck (Cassette Heater Unit-31/32)
0011-9630
iR7105 / iR7095 / iR7086 / iR7095P
< Installation >
1) Disconnect the connector of the paper deck from the host machine.
2) Release the paper deck from the host machine, and push down the latch plate [2] of the compartment [1] to open the compartment.
F-2-248
3) Remove the 3 screws [1], and detach the right cover [2] in the direction of the arrow.
F-2-249
[3] Relay harness unit 1 pc. [4] AC cable (for copier outlet) 1 pc.
[5] Screw (w/ washer) 1 pc. [6] Cable protection bush 1 pc.
[7] Power supply label 1 pc. [8] RS tightening screw (M4X8) 2 pc.
[9]* Stop ring 1 pc. [10]* RS tightening screw (M4X8; White) 1 pc.
* iR7105/7095/7086 Series only
Be sure of the following when installing the heater to the paper deck.
- The host machine and the power deck have properly been installed.
- The screws are identified by type (length, diameter) and location of use.
Turning Off the Main Power
When turning off the main power, be sure to go through the following in
strict sequence to protect the machine's hard disk:
1) Hold down on the power switch on the control panel for 3 sec or more.
2) Operate on the touch panel according to the shut-down sequence
indicated so that the main power switch may be turned off.
3) Turn off the main power switch.
4) Disconnect the power cable (for the power outlet).
[1]
[2]