Canon iR7086, Service Manual

Page: 85 / 735

Chapter 2
2-27
F-2-102
6) Hook the claw [2] of the cover support plate [1], and fix it in place using
2 screws (binding; M4X10) [3].
F-2-103
7) Lead the control panel interface cable [2] along the arm cover 2 [1]; then,
put the cover over the control panel arm unit.
F-2-104
8) Tighten the screw (binding; M4X10) [1] and screw [2].
F-2-105
9) Hook the claw [1] of the arm unit on the hole [2] in the Control panel arm
unit.
F-2-106
10) Tighten the screw (binding; M4X14) [2] and then the 4 screws [3] of the
arm unit [1].
F-2-107
11) Fix the control panel interface cable [1] in place using 2 wire saddles [2].
When putting the arm cover 2 in place, be sure it is correctly oriented in
relation to the plate [1].
[1]
[2]
[4]
[3]
[1] [2] [3] [3]
[1] [2]
[1] [1]
- When tightening the screw [1], be sure to hold down the arm cover 2.
- Be sure to tighten the screw at an angle.
- Be sure to tighten the screws in the correct order.
- Be sure that the arm unit is perpendicular in relation to the control panel
arm unit.
[1]
[2]
[1]
[2]
[3]
[3]
[1]
[2]