Canon Finisher-AK1, Service Manual

Page: 39 / 374

2
2
2-24
2-24
Technology > Intermediate Process Tray Assembly > Delivery Operation
Technology > Intermediate Process Tray Assembly > Delivery Operation
2) As needed, the staple unit is moved to empty itself of the waste staples in the waste staple
case.
CAUTION:
The waste staple in the waste staple case is detected by the sensor. When the waste
staple in the case reaches the specified amount (after approx. 5000 times),
the case moves down. The flag on the case blocks the sensor due to this movement
and it leads to the waste staple full alarm.
The machine determines the waste staple full 1000 times stapling after the alarm and
the operation stops. At the same time, the message 'Check the waste staple case.'
is displayed on the control panel. When the waste staple in the case is emptied out, the
host machine clears the waste staple full and the status is changed to ready.
Delivery Operation
1) The machine starts delivery of the stack at the end of alignment or stapling by rotating the
delivery roller in the direction of the arrow.(At non-staple mode delivery, the control of stack
delivery roller angle switching is performed.)
2) In the event of stapling on one side*, the assist stopper synchronises with the sheaf
delivery roller and moves in the direction of the arrow. This starts the paper eject action.
[2]
[1]
[3]
[4]
[1] Swing guide [3] Stack delivery roller
[2] Stapled stack of sheets [4] Assist stopper
F-2-36