Canon Finisher-AK1, Service Manual

Page: 209 / 374

5
5
5-38
5-38
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Delivery of Staple Stack (lower delivery) > Procedure
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Delivery of Staple Stack (lower delivery) > Procedure
5) Open the upper cover and measure displacement amount of the paper stack that is
stopped at the buffer assembly (displacement amount between the 1st sheet and the 2nd
sheet: A, displacement amount between the 1nd sheet and the 3rd sheet: B).
Repeat this work 5 times and check that the average of A and B is within the specified value
(A: 2.0mm +/- 0.5, B: 4.0mm +/- 0.5). If the result is out of the specified value, execute the
work as follows.
[1]
[A]
[B]
[2]
[3]
[B]
[A]
[1]
[2]
[3]
[1] 1st sheet
[2] 2nd sheet
[3] 3rd sheet
F-5-88
F-5-89
6) If A (displacement amount between the 1st sheet and the 2nd sheet) or B (displacement
amount between the 1nd sheet and the 3rd sheet) is out of the specified value, execute the
following work:
Take out the paper and close the upper cover.
Press push switch SW385 [1] once to get into the adjustment mode for A (displacement
amount between the 1st sheet and the 2nd sheet). Pressing push switch SW383 [2]
reduces the displacement amount while pressing SW384 [3] increases the displacement
amount.
(Correction amount is displayed on the LED [4])
• Adjustment range: +48 to -48 (correction amount by 2 units: 0.4mm)
(Adjustment level: amount per 2 units)
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[2] [3]
[4]
[1]
F-5-90