Canon Finisher-AK1, Service Manual

Page: 160 / 374

4
4
4-102
4-102
Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Press Unit > Procedure
Parts Replacing and Cleaning > Saddle Stitcher Assembly > Removing the Press Unit > Procedure
CAUTION:
When installing the Saddle Unit, adjust the positions by the following steps so that the
Rail Pins are fitted into the grooves of the Saddle Unit.
1) At the rear side of the Saddle Unit, fit the side surface [A] of the Connector Base of
the Saddle Unit with the side surface [B] of the rail on the right.
2) At the front side of the Saddle Unit, fit the back side [C] of the Saddle Inner Cover
(Lower) with the surface [D] of the Rail Unit.
[D]
[C]
[B]
[A]
3) Fit the 4 Rail Pins [1] into the 4 grooves [A] of the Saddle Unit.
[1]
[A]
F-4-249
F-4-250
Removing the Press Unit
■ Preparation
1) Open the Front Cover.
2) Pull out the Saddle Unit. (service position)(Refer to page 4-99)
3) Remove the Saddle Inner Cover (Lower).(Refer to page 4-89)
■ Procedure
1) Remove the Roller Fixation Plate (Front) [1].
• 2 Screws [2]
[1]
[2]
F-4-251