Canon Finisher-AK1, Service Manual

Page: 138 / 374

4
4
4-80
4-80
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Upper Guide Unit > Procedure
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Upper Guide Unit > Procedure
CAUTION:
When installing the Process Upper Guide Unit [1], be sure to align the positions as
shown below.
1) Hold the handle [2] and the Support Pin Base [B] so that the surface of the guide [A]
of the Process Upper Guide Unit [1] is at right angle.
[1]
[2]
[A]
[B]
F-4-189
2) Put the shaft [1] of the Process Upper Guide Unit into the hole [A] of the Finisher
Front Plate.
3) Move the pulley [2] of the Process Upper Guide Unit to the opening [B] of the
Finisher Rear Plate. Be careful not to hit the pulley [2] with peripheral parts.
[1]
[2]
[A]
[B]
F-4-190