Canon Finisher-AK1, Service Manual

Page: 141 / 374

4
4
4-83
4-83
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
5) Remove the Belt Controller Unit [1].
• 2 Wire Saddles [2]
• 2 Screws [3]
• 1 Belt [4]
[2]
[2]
[3]
[1]
x2
[4]
CAUTION:
When installing the Belt Controller Unit, be sure to align the slope angles [A] of the
guide surface of the Guide Lever (Front) [1] and the guide surface of the Guide Lever
(Rear) [2].The following shows the checking procedure.
[A]
[1]
[2]
F-4-197
F-4-196
1) Hook the belt [2] of the Process Upper Guide Unit on the pulley [1] of the Belt
Controller Unit, and then temporarily tighten the 2 screws [3].
At this time, the position should be such that the belt [4] can be correctly hooked on
the pulley [5].
[1]
[2]
[3]
[4]
[5]
x2
F-4-198