Canon Finisher-AK1, Service Manual

Page: 105 / 374

4
4
4-47
4-47
Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Sensor Unit > Procedure
Parts Replacing and Cleaning > Feed Assembly > Removing the Side Registration Sensor Unit > Procedure
4) Fit the Guide Plate [1] of the finisher to the groove [A] of the Puncher Unit to remove the
Puncher Unit [2].
• 2 Screws [3]
CAUTION:
Do not get the Puncher Unit [2] caught by the belt [4].
[1]
[2]
[3]
[3]
[3]
[4]
[A]
x2
[2]
F-4-97
Removing the Side Registration Sensor Unit
■ Preparation
1) Open the Front Cover.
2) Separate the finisher from the host machine.(Refer to page 4-18)
3) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
4) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Remove the Inner Cover (Upper) (when the Puncher Unit is installed).(Refer to page 4-22)
7) Remove the Puncher Unit (when the Puncher Unit is installed).(Refer to page 4-46)
■ Procedure
1) Remove the Side Registration Sensor Unit [1].
• 1 Flat Cable [2]
• 4 Screws [3]
[1]
[3]
[3]
[2]
F-4-98