Canon Finisher-AK1, Service Manual

Page: 283 / 374

5
5
5-112
5-112
Adjustment > Auxiliary Adjustment > Adjusting Alignment for Saddle Stapling
Adjustment > Auxiliary Adjustment > Adjusting Alignment for Saddle Stapling
13) Press switch SW383 [1] several times to execute folding and delivery of paper.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
14) Using this output result, measure displacement amount [A] [B] between the stapling
position at the front [1] and the stapling position at the rear [2].
In case of large displacement amount, be sure to adjust tilt of the saddle stapler by going
through the following procedure.
[A]
[B]
[1]
[2]
[1]
[2]
F-5-268
F-5-269
15) Loosen the 2 screws [1] that secure the saddle stapler.
[1]
[2]
16) Adjust tilt of the saddle stapler according to the displacement amount of stapling position.
• If the stapling position at the rear is displaced downward as shown in step 14) (in the case
of displacement amount [A])
Remedy: Move the stapler [1] in the direction of the arrow [A] to meet the specified
value.
• If the stapling position at the rear is displaced upward as shown in step 14) (in the case of
displacement amount [B])
Remedy: Move the stapler [1] in the direction of the arrow [B] to meet the specified
value.
17) Reverse steps 1) to 8) and 15) so that the finisher is ready to work.
F-5-270