Canon Finisher-AK1, Service Manual

Page: 139 / 374

4
4
4-81
4-81
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Belt Controller Unit > Procedure
4) Fit the 2 Support Pins [1] of the Process Upper Guide Unit to the 2 grooves [A] of
the finisher.
[1]
[1]
[A]
[A]
F-4-191
Removing the Belt Controller Unit
■ Preparation
1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Rear Cover.(Refer to page 4-20)
6) Open the Front Cover.
7) Remove the Inner Cover (Upper).(Refer to page 4-22)
8) Remove the Process Upper Guide Unit.(Refer to page 4-78)
■
Procedure
CAUTION:
• Avoid deformation of the 2 Process Upper Guides [1] and the 4 Paper Guides [2].
• Put the removed Process Upper Guide Units [3] with the Belt Controller Unit [4] side
up. Place a stack of paper (approx. 2 cm thick) or cardboards [6] under the handle [5]
to make it stabilized.
[2]
[2]
[5]
[3]
[3]
[4]
[6]
[1]
[1]
F-4-192