Canon Finisher-AK1, Service Manual

Page: 195 / 374

5
5
5-24
5-24
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Height of Corrugation Roller for Stack Delivery > Procedure
9) Press the Push Switch SW385 [1] to complete the height adjustment of the Corrugation
Roller.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
10) If the height of the Corrugation Roller is in the range, remove the heavy paper used
in step 7, install the Static Eliminator removed in step 2, and complete the adjustment.
11) If the height of the Corrugation Roller is out of the range, press the Push Switch
SW385 [1], and complete the preparation for the adjustment again. Press SW384 [2] five
times to display "E: Corrugation position adjustment" on LED [3].
F-5-51
12) By pressing the Push Switch SW385 [1], the current adjustment value is displayed
on LED [3]. Then, press SW383 [4] or SW384 [2] to change the adjustment value in
increments of 1 pulse.
• Adjustment range: +12 to -6 (shift amount per unit: 0.8 mm)
13)
Press the Push Switch SW385 [1] to complete the height adjustment of the
Corrugation Roller.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[4] [2] [1]
[3]
14) Enter in "A: Operation Check" mode by performing step 5 again, and measure
the height of the Corrugation Roller. Repeat steps 5 and later until the height becomes
appropriate, and then, finish this adjustment in step 10.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
F-5-52
F-5-53