Canon Finisher-AK1, Service Manual

Page: 191 / 374

5
5
5-20
5-20
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Lower Neat Alignment Plate > Procedure
Adjustment > Adjustment at Time of Parts Replacement > Adjusting the Alignment Position of the Lower Neat Alignment Plate > Procedure
6) By pressing the SW385 [1], the shift amount of the Front Neat Alignment Plate is
determined, and adjustment of the distance between the paper edge (rear side) [B] and the
Rear Neat Alignment Plate [2] starts.
7) By pressing the Push Switch SW383 [3] or SW384 [4], the adjustment amount is
determined, and the adjustment value is displayed on LED [5].
By pressing the SW383 [3], the Front Neat Alignment Plate [2] moves toward the rear by
approx. 0.2 mm. On the other hand, by pressing the SW384 [4], the Rear Neat Alignment
Plate [2] moves toward the front by approx. 0.2 mm.
• Adjustment range: +15 to -15 (shift amount per unit: 0.2 mm)
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[3] [4] [1]
[5]
[2]
[B]
F-5-40
8) After executing the adjustment, check that the distance (1) and (2) shown below become
appropriate so that there is no gap and paper is not leaned on the Alignment Plate.
• (1) Distance between the paper edge (front side) [A] and the Front Neat Alignment Plate [1]
• (2) Distance between the paper edge (rear side) [B] and the Rear Neat Alignment Plate [2]
If the distance is not appropriate, measure and write down the shift amount which will be
needed for readjustment.
[1] [2]
[B] [A]
9) Press the Push Switch SW385 [1] to finish the adjustment of Lower Neat Alignment Plate
position, and remove the paper stopped at the Bottom Delivery Outlet.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
10) If distance of the Lower Neat Alignment Plate is appropriate, adjustment is
completed.
11) If distance of the Lower Neat Alignment Plate is not appropriate, execute the
adjustment again from step 2.
F-5-41
F-5-42