Calrec BRIO 36, User Manual

Page: 177 / 210

177
Partial Routing
From version v1.1 the user has the ability to route individual spill legs to Mains, Groups and Aux Buses. This is achieved
by selecting the channel to route from (Fader 1), selecting the appropriate spill leg (LR Only), using the ‘Full Path’ button
to the right of the access block as highlighted in Figure 3 and routing to the appropriate Bus.
FIGURE 3 -
BUS ROUTING SWITCHES FOR LR ONLY SPILL LEGS
Note: that in Figure 3 the Main 1 and Group 1 routing displays are just showing the L and R indicators underneath the
routing switches. Selecting the ‘Full Path’ button again and this time selecting ‘Full Path’ returns the routing display back
to showing the routing for all the spill legs as shown in Figure 4 below.
FIGURE 4 -
BUS ROUTING SWITCHES FOR FULL PATH
When a partial route to a bus is made, i.e. only some of the spill legs are routed, the routing indicator from the ‘Full Path’
view shows the Route with the top right hand corner cut off and in addition the routing blocks underneath the ‘Full Path’
routing switches show which spill legs have been routed. So in Figure 4 Fader1’s 5.1 channel has routed just the front LR
spill legs to Main 1 and has routed the LR & C spill legs to Group 1.