Cabletron Systems SSR-GLX19-02, User Manual

Page: 68 / 495

Chapter 6: Configuring SSR Bridging
68 CoreWatch User’s Manual
Note:
Clicking a module in the Address Mode list rather than double-clicking it
selects all of the module’s ports that are currently using address-based
bridging. Use this method if you are configuring all the ports on a module to
use flow-based bridging.
5. Click the Add button.
Configuration Expert moves the selected port from the Address Mode list to the
corresponding module in the Flow Mode list.
6. Click OK .
Configuration Expert adds the port to those found in the Flow Mode Bridging object,
which is located in the Bridging Mode object.
Configuring a Port for Address-Based Bridging
Ports are configured to use address-based bridging by default. If you previously
configured a port for flow-based bridging and later decide you want that port to use
address-based bridging, you can change its bridging mode. To do so, take the following
steps:
1. Start Configuration Expert if you have not already done so.
2. Open the configuration file you want to modify and then double-click that file’s
Bridging Configuration object.
3. Double-click the Bridging Mode object.
A Bridging Mode dialog box similar to the following appears: