Cabletron Systems SSR-GLX19-02, User Manual

Page: 166 / 495

Chapter 11: Configuring the SSR for IPX Routes
166 CoreWatch User’s Manual
desired ACL and apply it as discussed in “Applying ACLs to IP or IPX
Interfaces” on page 224 .
14. If you specified you wanted to apply an ACL, use the Apply IPX ACL panel that
appears to apply an ACL to the interface.
Figure 94. Access Control List: Edit ACL panel (single port)
To use the wizard to apply an IPX ACL, take the following steps:
a. Select the ACL you want to apply from the ACL Name drop-down list. This will
apply all ACLs with that name.
Configuration Expert lets you configure multiple ACLs that use different rules but
have the same name. You can apply IPX, IPX RIP, and IPX SAP ACLs to an IPX
interface.
b. Use the Filter State check boxes to specify whether you want to filter out inbound
traffic ( Input ), outbound traffic ( Output ), or both inbound and outbound traffic.
You can apply up to two of each of the different IPX ACLs (IPX, IPX RIP, and IPX
SAP) to an IPX interface. When applying two ACLs of the same type, one ACL
must govern the inbound traffic and the other must govern the outbound traffic. If
you want to apply multiple ACLs to an IPX interface, finish using the wizard to
apply an ACL, then apply the additional ACLs as discussed in
“Applying ACLs to
IP or IPX Interfaces” on page 224 .
c. Click Finish .