Cabletron Systems SSR-GLX19-02, User Manual

Page: 171 / 495

CoreWatch User’s Manual 171
Chapter 11: Configuring the SSR for IPX Routes
12. Specify whether you want to apply an ACL to the interface by doing one of the
following.
– To not apply an ACL, select No . Then click Finish , which completes the
configuration of the interface but does not apply any ACL to that interface.
Configuration Expert adds the new interface to those found in the IPX interfaces
bound to VLAN object.
– To apply an ACL to the interface, select Yes and click
Next
.
Note:
You will be able to apply an ACL while creating an IPX interface only if
you previously created the ACL. If you plan to apply an ACL that you
have not defined yet, finish creating the interface. Then configure the
desired ACL and apply it as discussed in
“Applying ACLs to IP or IPX
Interfaces” on page 224 .
13. If you specified you wanted to apply an ACL, use the Apply IPX ACL panel that
appears to apply an ACL to the interface.
Figure 101. Access Control List: Edit ACL panel
To use the wizard to apply an IPX ACL, take the following steps:
a. Select the ACL you want to apply from the ACL Name drop-down list. This will
apply all ACLs with that name.
Configuration Expert lets you configure multiple ACLs that use different rules but
have the same name. You can apply IPX, IPX RIP, and IPX SAP ACLs to an IPX
interface.
b. Use the Filter State check boxes to specify whether you want to filter out inbound