Cabletron Systems SSR-GLX19-02, User Manual

Page: 115 / 495

CoreWatch User’s Manual 115
Chapter 8: Configuring IP Interfaces for the SSR
desired ACL and apply it as discussed in “Applying ACLs to IP or IPX
Interfaces” on page 224 .
15. If you specified you wanted to apply an ACL, use the Apply IP ACL panel that
appears to apply an ACL to the interface.
Figure 57. Apply IP ACL panel (single port)
To use the wizard to apply an IP ACL, take the following steps:
a. Select the ACL you want to apply from the ACL Name drop-down list. This will
apply all ACLs with that name.
Configuration Expert lets you configure multiple ACLs that use different rules but
have the same name. You can only apply IP ACLs to an IP interface.
b. Use the Filter State check boxes to specify whether you want to filter out inbound
traffic, outbound traffic, or both inbound and outbound traffic.
Select Input to filter inbound traffic and select Output to filter outbound traffic.
Selecting both check boxes filters both inbound and outbound traffic.
c. Click Finish .
Configuration Expert adds the new interface to those found in the IP interfaces
bound to Ports object.
Note:
When you apply an ACL to an interface, the SSR appends an implicit
deny rule to that ACL. The implicit deny rule denies all traffic. If you
intend to allow all traffic that does not match your specified ACL rules to