Brunswick GS-X Series, Operation & Service Manual

Page: 253 / 302

Section Rev. February 2009
Section 7: Preventative Maintenance
7-7
Sweep Wagon Assembly
1. Inspect the condition of the sweep wagon frame and frame welds. Check the roller mounting
and adjustment. Check the conditions of the pusher rods and pusher rod bushings. Inspect
the conditions of the protector blocks and block mounting hardware. Check all sweep wagon
hardware.
2. Inspect the condition of the sweep board and adapters. Check the adjustment of the sweep
board and adapters.
3. Inspect the condition of all sweep release mechanism components. Check all sweep release
mounting hardware. Inspect for missing springs or worn linkage and pivot bushings. Check
the condition of the chain and pivot bearing. Check the operation of the solenoid. Inspect the
solenoid cable routing.
4. Inspect the sweep attenuator and sweep shock absorber for loose or missing hardware. Check
the attentuator and “G” switch for proper adjustment. Inspect all pivot points for wear. Inspect
the “G” switch cable routing.
Setting Table Assembly
1. Inspect the setting table frame for wear or broken welds. Check for loose or missing hardware.
Check the vertical swing shaft stop bolt for proper adjustment. Inspect the condition of the
vertical helper springs.
2. Check for loose or missing spotting tong and geared rack hardware. Inspect the “ST” switch
mounting and check the adjustment. Inspect the condition of the tongs, gears and toothed racks.
Check the operation of the tongs and inspect the tong dampers for wear.
3. Inspect all cable channels and conduits for wear. Check that all channels and conduits are
secured to the frame. Inspect the condition of the table harness plug and its mounting bracket.
4. Check the adjustment on the stop collars. Inspect the swing shaft bearings for wear. Inspect
the condition of the table spring. Inspect the condition and mounting of the table jam roller.
Check the adjustment of the horizontal stop bolt.
5. Inspect the TS-1 jam switch mounting and adjustment. Check for loose or missing hardware
and springs.
6. Inspect all pin holders and pin holder solenoids for correct mounting. Inspect all pin holder
switches for tight mounting. Check all pin holder connectors and wiring for routing and
connection. Inspect the adjustment on the pin detector plates.
7. Inspect the mounting of the table racks to the table. Check the adjustment and condition of the
small roller support assembly. Check the condition of the T-stop. Check the mounting of the
OOR actuator cam. Inspect the condition of the chain and pivot bearing.