Brunswick GS-X Series, Operation & Service Manual

Page: 163 / 302

Section Rev. February 2009
Section 4: Pinsetter Cycles
4-13
First Ball - Short Cycle
A short cycle occurs in the following situations after rolling the first ball.
A. The 7 pin was the only pin knocked down by a ball.
B. The 10 pin was the only pin knocked down by a ball.
C. No pins were knocked down by a ball (gutter ball).
If one of these conditions occurs, the Pinsetter CPU determines that there is no deadwood and the
sweep operation is not necessary. The table lowers on top of the pins and then returns to the home
position. Decreasing the length of time necessary to complete the first ball cycle. Refer to Figure 4-8.
(3)
CW
(2)
CCW
NOTE: RESULTS BECAUSE OF
A. 7 PIN DOWN ONLY
B. 10 PIN DOWN ONLY
C. GUTTER BALL
NO SWEEP NECESSARY
(10)
READ
PIN
HOLDERS
(9)
ST
OP
&
REVERSE
TA
BL
E
MOT
OR
(8)
OPEN
GRIPPERS
A
(13)
SWITCH
CLUSTER
(1)
TABLE
HOME
(14)
OOR
SWITCH
(15)
DETECTION
STROKE
(16)
RAIS
E
S
WEEP
(5)
PRELOAD
PINS
(6)
(7)
(4)
READY
FOR
SECOND
BALL
(12)
SWEEP
DOWN
(11)
SWEEP
FORWARD
G G
SM SM
A C B B
(17)
DETECTOR
HEIGHT
ST ST
(18)
SPOTTING TONGS
OPEN
Figure 4-8. First Ball Short Cycle.
(1) TABLE HOME (2) COUNTERCLOCKWISE (3) CLOCKWISE
(4) READY FOR SECOND BALL (5) PRELOAD PINS (6) NOTE: RESULTS BECAUSE OF
A. 7 PIN DOWN ONLY
B. 10 PIN DOWN ONLY
C. GUTTER BALL
(7) NO SWEEP NECESSARY (8) OPEN GRIPPERS (9) STOP AND REVERSE TABLE
MOTOR
(10) READ PIN HOLDERS (11) SWEEP FORWARD (12) SWEEP DOWN
(13) SWITCH CLUSTER (14) OUT-OF-RANGE SWITCH (15) DETECTION STROKE
(16) RAISE SWEEP (17) DETECTOR HEIGHT (18) SPOTTING TONG OPEN