Brunswick GS-X Series, Operation & Service Manual

Page: 169 / 302

Section Rev. February 2009
Section 4: Pinsetter Cycles
4-19
Second Ball - Single Detect
Second ball - single detect is a second ball cycle used when the pinsetter is not used to provide scorer
information to an automatic scorer. This cycle would be used when automatic scorers are not present
or when an external device is used to provide pinfall to the automatic scoring system. Refer to
Figure
4-11.
(2)
LOADING
PINS
(3)
CW
(14)
SWITCH
CLUSTER
(1)
TABLE
HOME/UP
(13)
SWEEP
DOWN
(12)
SWEEP
FORWARD
(10)
CLOSE
GRIPPERS
(1
1)
OPEN
GRIPPERS
T
O
SET
NEW
PINS
(16)
SWEEP
(7
)
RAIS
E
S
WEEP
(4)
STROKE
LIMITER
SOLENOID
ENERGIZED
(8)
NEW
PINSETTING
STROKE
(9)
OPEN 7 AND
10 PIN
GRIPPER
(5)
READY
FOR FIRST
BALL
(6)
LOAD 7
AND 10 PIN
IF AVAILABLE
A A A
D C B
A
G G
SM SM SM SM
(15)
NO
DETECTION
STROKE
(17)
DETECTION
HEIGHT
ST ST
Figure 4-11. Second Ball Single Detect Cycle.
(1) TABLE HOME/UP (2) LOADING PINS (3) CLOCKWISE
(4) STROKE LIMITER SOLENOID (5) READY FOR FIRST BALL (6) LOAD 7 AND 10 PIN IF AVAILABLE
ENERGIZED
(7) RAISE SWEEP (8) NEW PINSETTING STROKE (9) OPEN 7 AND 10 PIN GRIPPER
(10) CLOSE GRIPPERS (11) OPEN GRIPPERS SET NEW PINS (12) SWEEP FORWARD
(13) SWEEP DOWN (14) SWITCH CLUSTER (15) NO DETECTION STROKE
(16) SWEEP
During this cycle the table does not lower to detect the pins’ it simply sweeps away any pins left on the
pin deck and sets ten new pins in preparation for a first ball cycle.
1. The ball detect occurs.
2. In response to the ball detect signal the sweep release solenoid energizes to lower the sweep into
the guard position actuating switch “G”. The ball door solenoid energizes, locking the ball door
for three seconds.
3. The sweep motor turns on pulling the sweep back then forward to clear the pin deck. When the
sweep wagon is fully forward, switch “SM” closes and the sweep motor is turned off.