Brunswick GS-X Series, Operation & Service Manual

Page: 112 / 302

3-20
Section 3: Nexgen Electronics
Section Rev. February 2017
NOTE: The following selections are available only when the STOP/RUN switches for both
pinsetters are in the STOP position.
Setup - This selection allows the user to configure the pinsetter’s operating
characteristic. A submenu for this selection has the following choices:
NOTE: Use the enter button to select the desired choice then arrow buttons to choose yes or no.
Firmware Version:
The firmware version is displayed in the setup menu
for firmware versions 4.95.21 and later.
Left Lane ## - Sets the lane ID for the lane pair. Currently, this selection
is not used.
Double Detect: (Y or N) -
Gives the pinsetter the choice of detecting
pin activity on second ball. If a scoring system is present that has the
capability of interfacing with the CPU, it can use the pin holder switch
information to determine the bowler’s pinfall. If no scoring system is
available, or the scoring system uses a scanner or camera for determining
pinfall, turning this switch on disables the detection stroke of the setting
table during the second ball.
Y - Double Detect - Set if a scanner or CCD Camera are not used.
(Frameworx scoring system) (default)
N
- Single Detect - Set if a scanner, CCD Camera or VPS are used or if
no scoring system is used.
Enable OOR: (Y or N) - Enable or disables the out-of-range cycle.
Most bowling organizations require that the pinsetter stop and any
deadwood (pins that have been knocked over but are still in the field of
play) must be removed before the next ball can be rolled. If your center
has sanctioned leagues that require deadwood be removed before choose
“Y” otherwise choose “No”.
Y - Pinsetter stops for an out-of-range pin. (default)
N -
Ignores an out-of-range pin.
Table Delay: (Y or N) - This selection controls the delay of the setting
table operation after the sweep drops to a guarded position.
Y -
Delayed setting table - USBC, FIQ..., compliant delay. (Default )
N -
Quick setting table - No delay after sweep drop.
Distrib Stop: (Y or N) - This selection determines if the distributor will
stop after all 10 pins have been delivered to the pin holders while waiting
for a 2nd ball cycle. The suggested setting for this option is “N”.
Y - Stop enable - Distributor stops after ten pins have loaded while
waiting for a 2nd ball.
N - Stop disabled - Continuous distributor operation while loading
pin. (default)