Brunswick GS-X Series, Operation & Service Manual

Page: 256 / 302

7-10 Section 7: Preventative Maintenance
Section Rev. February 2009
Main Frame Assembly
1. Inspect the main frame. Check for wear points or broken welds. Check for loose or missing
hardware. Check the main support braces and verify they are secure.
2. Inspect the pinlight fixture. Check and verify that the fixture is secure. Check the lamp and
lamp sockets. Check the power cord routing.
3. Inspect the guards. Check for wear points. Check for loose or missing hardware. Check for
any missing guards. Check the work platform and the work platform braces and hardware.
Distributor Assembly
1. Inspect the distributor frame assembly. Check for worn or damaged frame components and
welds. Check for loose or missing hardware. Check and verify that the dust pan is secure.
Check the distributor rails and extensions for wear or cracks. Check the distributor stations for
wear or cracks. Inspect the lower pin guides for bent or missing parts. Check the corner turn
rails and corner pin turn devices for loose or missing hardware and for correct adjustment.
2. Inspect the distributor shafts, pulleys and belting. Check for worn or damaged shafts or
bearings. Check for worn or cracked pulleys. Inspect the condition of the distributor belting.
Check the condition of distributor gears and verify proper gear mesh. Check the alignment of
all shafts, pulleys and belting. Check for any missing shaft, bearing or pulley hardware.
3. Inspect the distributor pin stations. Verify all pin stops are in place. Check the pin sliders
for free operation. Check the pin sliders for cracks or breaks. Check for loose or missing pin
station hardware. Check the ejector flaps for wear or cracking. Check the retaining bows for
wear or cracking. Check for worn, cracked or misadjusted pin release levers. Verify that all pin
station springs are in place. Inspect the top and bottom housings for cracks or wear.