Brunswick GS-X Series, Operation & Service Manual

Page: 126 / 302

3-34
Section 3: Nexgen Electronics
Section Rev. February 2017
Safety Power Controller (Version III)
(9)
3 PHASE
POWER IN
(13)
CONTROL
MODULE
(11)
CONTACTORS
(10)
POWER OUT
TO NEXGEN
(12)
POWER
SUPPLY
(2)
RESTART
BUTTON
(3)
EMERGENCY STOP
BUTTON
(7)
FUSE
(8)
MAIN
POWER
SWITCH
(6)
RESTART PHOTOSENSORS
LED (GREEN)
(5)
READY FOR RESTART
LED (YELLOW)
(4)
POWER ON
LED (RED)
(14)
FRONT
PHOTOSENSOR
RESTART
(15)
DOOR
INTERLOCK
(16)
MASKING UNIT
INTERLOCK
(17)
SEND
PHOTOSENSOR
(18)
RECEIVE
PHOTOSENSOR
BOTTOM VIEW
(1)
HOLD TO RUN
ACCESS HOLE
Figure 3-14. Safety Power Controller - Version III
(1) Hold To Run Access Hole - Location to mount the optional Hold-To-Run Switch.
(2) Restart Switch - Button used to restart the Safety Power Controller, as indicated by the yellow
restart LED, after a power failure or interruption of power caused by opening the guard or
masking unit interlock switch or photo sensors.
(3) Emergency Stop Switch - Push this button to immediately remove power from the Nexgen box
and shut down power to both pinsetters of the lane pair.
(4) Power On LED (Red) - This LED Turns “On” when the safety controller has applied power to
the Nexgen.
(5) Ready For Restart LED (Yellow) - This LED Turns “On” when all the interlock switches and
sensors are in the ready to operate position and the safety controller is ready for a restart. Refer
to (2) Restart Switch.
(6) Restart Photo Sensors LED (Green) - This LED Turns “On” when the photosensor beam at
the masking unit has been interrupted to indicate that the sensor needs to be restarted. Once the
cause of the interruption has been determined, press the Photosensor Restart button to reset the
photosensor circuit
(7) Fuse - .25A slow blow fuse used to protect power going to the power supply module.