Brunswick GS-X Series, Operation & Service Manual

Page: 114 / 302

3-22
Section 3: Nexgen Electronics
Section Rev. February 2017
Trouble Blink: (Y or N) - This selection is available on machines with
software version 4.95.21 and higher. This selection determines whether
the light on the elevator will perform as a traditional trouble light and
be “off” during machine operation or as a status light and remain “On”
during machine operation.
Y - Normally “Off”, “flashing” for errors.
N
- “Off” when machine is turned off, “On” when the machine is
operating, flashing for errors. (default)
Distrib Time: (45, 50, 55, 60) - Distributor time out. This selection
determines how long the distributor runs at the end of a pinsetter cycle
if an addition ball detection does not occur. The selection is available on
machines with software version 4.95.21 and higher.
45 - 45 seconds (default)
50 - 50 seconds
55
- 55 seconds
60
- 60 seconds
Shdw Bwl Time: (0, 1, 2, 3) : This selection is available on machines
with software version 4.95.21 and higher. It determines the amount of
time the ball accelerator will continue running after the pinsetter has
been turned off in order to allow the ball to return to the bowler. The pin
light is off during this time and the pinsetter will not cycle.
00 - Disabled (default)
01 -
1 minute
02 -
2 minutes
03 - 3 minutes
NOTE: For centers that have either Vector Desk version 3.3.0.863 (or higher) or Vector
Plus version 2.8.23 (or higher), this feature can also be implemented through the scorer. It
is recommended that the 0 be used as the NexGen setting when the scorer is controlling this
feature.