Brunswick GS-X Series, Operation & Service Manual

Page: 80 / 302

2-14
Section 2: Electronics, Switches, Solenoids and Motors
Section Rev. December 2016
TS-2 Switch
This table jam switch is mounted inside the right side frame near the switch cluster. This is a jam
switch that is activated only when the table is not able to return to its up home position. If a pin or
broken part becomes wedged between the top of the setting table and the bottom of the distributor, the
table is prohibited from rising. As the table crank continues to turn, additional torque causes the chain
sprocket and shaft to overpower a tension spring attached to the actuator lever. Any time this switch
is closed, the table motor will reverse the table for 1.5 seconds or until the “C” switch is closed. The
machine will shut off, an error code “J2” or TS2 JAM will appear on the error code display and the
status light will flash.
Turn the Stop/Run switch to the Stop position and clear the jam. Once the jam has been cleared, turn
the stop/run switch to the run position.
(1)
TS 2
TABLE JAM SWITCH
(2)
RIGHT
GUIDE TOWER
(3)
ACTUATOR
LEVER
(4)
TENSION
SPRING
(5)
SPROCKET
SHAFT
Figure 2-12. TS-2 Table Jam Switch
(1) TS2 TABLE JAM SWITCH (2) RIGHT GUIDE TOWER (3) ACTUATOR LEVER
(4) TENSION SPRING (5) SPROCKET SHAFT
Error Code
TS2 Jam J2 JAM SWITCH TS2 (FOUND)