Brunswick GS-X Series, Operation & Service Manual

Page: 173 / 302

Section Rev. February 2009
Section 4: Pinsetter Cycles
4-23
Second Ball - Out-of-Range
A second ball out-of-range occurs only when the Pinsetter CPU is set up for double detection. The
table will come down on top of an off spot pin as happens in a first ball out-of-range. This causes the
pinsetter to stop and requires the mechanic to restart the pinsetter. Refer to
Figure 4-13.
Figure 4-13. Second Ball Out-Of-Range Cycle.
(1) TABLE UP HOME (2) COUNTERCLOCKWISE (3) CLOCKWISE
(4) DROP SWEEP (5) LOAD PINS IN TABLE (6) STROKE LIMITER SOLENOID
ENERGIZED
(7) OUT-OF-RANGE SWITCH (8) SHORTENED DETECTION (9) NO SWEEP
STROKE
(10) SHORT STROKE (11) RAISE SWEEP (12) SWEEP
(13) NEW PINSETTING STROKE (14) READY FOR FIRST BALL (15) LOAD 7 AND 10 PIN IF
AVAILABLE
(16) OPEN 7 AND 10 PIN GRIPPERS (17) CLOSE GRIPPERS (18) OPEN GRIPPERS SET NEW PINS
(19) OPEN GRIPPERS (20) IMMEDIATE DROP OF SWEEP (21) PINSETTER RESTART
(22) PINSETTER SHUT OFF TROUBLE (23) SENSE OUT-OF-RANGE (24) SWEEP FORWARD
LIGHT ON ERROR CODE “PO” IGNORE PIN HOLDERS
(25) SWEEP DOWN (26) CLUSTER SWITCHES (27 SPOTTING TONGS OPEN
(28) OPTIONAL STROKE
(IF PINS MUST BE LOADED)
1. A ball detect occurs.
2. The sweep release solenoid energizes to lower the sweep into the guard position activate the
“G” switch. The ball door solenoid energizes locking the ball door for three seconds.
3. The table motor runs counterclockwise to allow the table to lower. The cam on the table shaft
leaves switch “A” and goes toward switch “B.”