Spa
Quick Start Guide
Balboa VS/GS100 System for VL 200 Topside Control
For use with Four Winds Spas Storm Series: One pump, 115Volt pack. Non-Wifi Topside
.
Start-up
Your spa will enter Priming Mode ( ) after the initial start-up
sequence.
During Priming Mode, press “Jets” button
repeatedly and be sure the pump is free of air.
Priming
Mode lasts less than 5 minutes. Press “Warm” or “Cool” to exit.
After Priming Mode, the spa will run in its preset mode (see
Mode section for details).
Temp Control (80°F - 104°F / 26°C - 40°C)
The last measured water temperature is constantly displayed.
The water temperature displayed is current only when the
pump has been running for at least 1 minute.
To display the set temperature, press “Warm” or “Cool” once. To
change the set temperature, press a temperature button again
before the display stops flashing. Each press of “Warm” or
“Cool” will adjust the set temperature.
After three seconds, the display will stop flashing and begin to
display the current spa temperature.
Jets
Press “Jets” to turn the pump on or off, and to shift between low
and high speeds (if equipped). If left running, the pump will turn
off after a preset length of time, which on some systems may be as
long as 2 hours for low speed. Low speed may run automatically at
times, during which it cannot be deactivated from the panel, but
high speed may be operated.
Pump 1 low-speed is responsible for heating and filtration. In
multi-button sequences, if the buttons are pressed too quickly in
sequence, they may not register.
Light
Press “Light” to operate the spa light. Turns off after 4 hours.
Mode
Depending on system configuration, mode changing may not be
available and will be locked in Standard Mode.
Mode is changed by pressing “Warm” then “Light”.
Standard Mode
maintains set temperature. will be displayed
momentarily when you switch into Standard Mode.
Economy Mode
heats the spa to the set temperature only during
filter cycles. will display when water temp is not current, and
will alternate with water temp when the pump is running.
Sleep Mode
heats the spa to within 20°F/10°C of the set
temperature only during filter cycles. will display when water
temp is not current, and will alternate with water temp when the
pump is running.
Preset Filter Cycles
The first preset filter cycle begins 6 minutes after the spa is
energized. The second preset filter cycle begins 12 hours later.
Filter duration is programmable for 1, 2, 3, 4, 5, 6, 7, or 8 hours.
It is important to set filter cycles on a pattern. We recommend
programing cycles at 7 am & 7 pm and avoiding the hours
from 10am-5pm.
To program, press “Warm,” then “Jets.” Press temperature buttons
to adjust. Press “Jets” to exit programming.
Automatic polling (in Standard Mode only)
The pump will activate for 1 minute to check the temperature:
- every 30 minutes
- whenever any other pump or blower is turned on
- whenever the set temperature is raised
This document covers VS and GS systems 300F using software v41 only with Balboa Panels VL200 through VL406.
Download complete user guide at http://www.balboawatergroup.com/getdoc.cfm?id=1155
