7-19
12
Incorrect cutting in Y direction.
a. Incorrect Y-direction cutting position.
b. Defective
Y-cutter.
Problem Check
Item
Cause Remedy
Repair
See
Section
Does the right cutter move
when the mode is changed?
Y-cutter guide R and
adjustment plate
incorrectly installed.
Correctly
reassemble the
body cover.
Does the left cutter move
when the Y-carriage
moves?
Y-cutter arm and Y-
cutter guide incorrectly
installed.
Correctly
reassemble Y-cutter
arm.
3.3.3
3.3.4
3.3.5
3.7
4.12
Right cut position is always
displaced in one direction.
Incorrect adjustment
of slide plates.
Readjust.
−−−
Left cut position is always
displaced in one direction.
Incorrect adjustment
of Y-sensor unit.
Readjust the Y-
sensor unit.
−−−
a. Incorrect Y-
direction
cutting position
Does Y-cutter arm move
smoothly?
Defective Y-cutter arm
movement.
Apply KS64F silicon
grease to Y-cutter
arm shaft and
sensor shaft.
3.3.1
3.3.3
3.3.4
3.3.5
3.4
Is the Y-cutter unit correctly
installed?
Incorrectly installed Y-
cutter unit.
Correctly install the
Y-cutter unit.
b. Defective Y-
cutter
Y-cutter makes jagged
cuts?
Defective Y-cutter
unit.
Replace Y-cutter
unit.
4.18
Summary of Contents for LX-1200
