Beam MG200, User Manual

Page: 62 / 291

MG200 USER MANUAL
62 of 269
©
2019 BEAM
When Connect-on-demand is selected, it means the Internet
connection will be established only when detecting data
traffic.
When
Connect Manually is selected, it means you need to
click the Connect button to dial up the connection manually.
Please Navigate to Status > Network > WAN & Uplink tab
for details.
Note : If the WAN interface serves as the primary one for
another WAN interface in Failover role (and vice versa), the
Connection Control parameter will not be available on both
WANs as the system need to
set it to “Auto - reconnect”
Maximum Idle
Time
Optional field.
Default setting:
600
(seconds).
Enter the maximum Idle time setting to disconnect the
internet connection when the connection idle time is out.
Value Range: 300 - 86400.
Note : This field is available only when Connect-on-demand
or Connect Manually is selected as the connection control
scheme.
Time Schedule
Mandatory field.
Default setting:
(0)
Always is selected.
When (0) Always is selected, it means this WAN is under
operation all the time. When you set other schedule rules,
there will be other options to select. Please Navigate to
User
Rule > Scheduling for details.
MTU Setup
Optional field.
Uncheck by default.
Check the Enable box to enable the MTU (Maximum
Transmission Unit) limit and enter the
MTU for the 3G/4G
connection.
MTU refers to Maximum Transmission Unit. It specifies the
largest packet size permitted for Internet transmission.
Value Range: 1200 - 1500.
IP Pass-through
(Cellular Bridge)
Disabled by default.
String format for
Fixed MAC :
MAC address, e.g.
00:50:18:aa:bb:cc
When Enable box is checked, it means the MG200 will directly
assign the WAN IP to the first connected local LAN client.
However, when an optional
Fixed MAC is filled-in a non-zero
value, it means only the client with this MAC address can get
the WAN IP address.
Note : When the IP Pass-through is on, NAT and WAN IP
Alias will be unavailable until the function is disabled again.
NAT Check by default.
Uncheck the box to disable NAT (Network Address
Translation) function.
IGMP
Default setting:
Disable .
Select Auto to enable IGMP function.
Check the Enable box to enable IGMP Proxy .
WAN IP Alias
Unchecked by
default.
String format: IP Check the box to enable WAN IP Alias and fill in the IP
address you want to assign.