Beam MG200, User Manual

Page: 192 / 291

MG200 USER MANUAL
192 of 269
©
2019 BEAM
To Interface
Mandatory field.
Default setting:
Any .
Define the selected interface to be the packet-leaving interface of
the router. If the packets to be filtered are entering from
LAN to
WAN, then select WAN for this field. Or VLAN-1 to WAN then
select WAN for this field. Other examples are VLAN-1 to VLAN-2.
VLAN-1 to WAN.
Select
Any to filter packets leaving the router from any interfaces.
Please note that two identical interfaces are not accepted by the
router. e.g., VLAN-1 to VLAN-1.
Source IP
Mandatory field.
Default setting:
Any .
This field is to enter the Source IP address .
Select Any to filter packets coming from any IP addresses.
Select Specific IP Address to filter packets coming from an IP
address.
Select IP Range to filter packets coming from a specified range
of IP address.
Select IP Address-based Group to filter packets coming from a
pre-defined group. Note: group need to be pre-defined before
this option become available. Refer to
User Rule > Grouping >
Host grouping. You may also access to create a group by the
Add Rule shortcut button.
Destination
IP Mandatory field.
Default setting:
Any .
This field is to enter the Destination IP address .
Select Any to filter packets that are entering to any IP addresses.
Select Specific IP Address to filter packets entering to an IP
address entered in this field.
Select
IP Range to filter packets entering to a specified range of
IP address entered in this field.
Select
IP Address-based Group to filter packets entering to a
pre-defined group selected. Note: group need to be pre-defined
before this selection become available. Refer to
User Rule >
Grouping > Host grouping. You may also access to create a
group by the Add Rule shortcut button. Setting done through
the Add Rule button will also appear in the Host grouping
setting window.
Source MAC
Mandatory field.
Default setting:
Any .
This field is to enter the Source MAC address .
Select Any to filter packets coming from any MAC addresses.
Select Specific MAC Address to filter packets coming from a
MAC address.
Select
MAC Address-based Group to filter packets coming from
a pre-defined group selected. Note: group need to be pre-
defined before this selection become available. Refer to
User
Rule > Grouping > Host grouping. You may also access to
create a group by the Add Rule shortcut button.
Protocol
Mandatory field.
Default setting:
Any
(0) .
For Protocol , select Any to filter any protocol packets
Then for Source Port , select a predefined port dropdown box
when Well-known Service is selected, otherwise select User-
defined Service and enter a port range.