Beam MG200, User Manual

Page: 13 / 291

MG200 USER MANUAL
13 of 269
©
2019 BEAM
1.2 MG200 overview
1.2.1 Front panel
# Description Notes
A GPS antenna
port Connect GPS antenna*
B WAN/LAN1
port Connect RJ45 cable for WAN/LAN connection. WAN or LAN can be configured in
MG200 web UI. See Section 3.1.2.2 Ethernet WAN Connection Setup.
C LAN2 port Connect RJ45 cable for LAN connection.
D Status LED Indicates MG200 status.
E RESET button Rest the MG200 to factory default settings by holding the reset button down for 6
seconds then release.
1 Power OFF: MG200 is powered off.
ON: MG200 is powered on by power source.
2 Wi-Fi OFF: Wi-Fi is disabled.
Steady ON: Wi-Fi is enabled.
Slow Flash: Data packets are transferring.
Fast Flash: MG200 is in Recovery mode.
3 LTE signal OFF: No cellular signal.
Steady ON: Cellular signal strength >= 50%.
Low Flash: Cellular signal strength < 50%.
4 GPS OFF: GPS function is disabled, GPS antenna is disconnected, or there is no GPS
signal. Steady ON: GPS signal is locked.
Flash: the MG200 is searching for GPS signal, no GPS lock.
5 SIM A OFF: SIM card is not inserted or not used for 3G/4G connection.
ON: SIM Card A is inserted and active.
6 SIM B OFF: SIM card is not inserted or not used for 3G/4G connection.
ON: SIM Card B is inserted and active.
* The GNSS Antenna is an optional accessory, that is not included in the standard package. If you intend to use
the provided GNSS function, please purchase an active GPS antenna and install it to the corresponding SMA
connector in advance.
A
B
D
E
1
2
3
4
5
6
C