Beam MG200, User Manual

Page: 113 / 291

MG200 USER MANUAL
113 of 269
©
2019 BEAM
RTS/CTS is a collision avoidance technique.
It means RTS never activated when the threshold is set to 2347 .
Fragmentation
Default setting:
2346.
Wireless frames can be divided into smaller units (fragments) to
improve performance in the presence of RF interference at the
limits of RF coverage.
WMM
Enabled by
default.
WMM (Wi-Fi Multimedia) can help control latency and jitter
when transmitting multimedia content over a wireless
connection.
Short GI
Default setting:
400ns .
Short GI (Guard Interval) is defined to set the sending interval
between each packet. Note that lower Short GI could increase
not only the transition rate but also error rate .
TX Rate
Default setting:
Best .
It means the data transition rate . When Best is selected, the
MG200 will choose a proper data rat e according to signal
strength .
RF Bandwidth
Default setting:
Auto .
The setting of RF bandwidth limits the maximum data rate.
Transmit Power
Default setting:
100% .
Normally the wireless transmitter operates at 100% power. Alter
the
transmit power to control the Wi-Fi coverage .
WIDS
Disabled by
default.
The WIDS (Wireless Intrusion Detection System) will analyze all
packets and make a statistic table in Wi-Fi status.
Navigate to
Status > Network > Wi-Fi tab for detailed WIDS
status.
Save Button. Click the Save button to save the current configuration.
Undo Button.
Click the Undo button to restore configuration to previous
setting before saving.
3.4 IPv6
The IPv6 page allows you to set the IPv6 connection type to access the IPv6 network. The MG200 supports
various types of IPv6 connection on WAN-1, including DHCPv6 .
DHCPv6
DHCP in IPv6 does the same function as DHCP in IPv4. The DHCP server sends IP address, DNS server addresses
and other possible data to the DHCP client to configure automatically. The server also sends a lease time of the
address and time to re-contact the server for IPv6 address renewal. The client has then to resend a request to
renew the IPv6 address.
Navigate to the Network > IPv6 > Configuration tab.
The IPv6 Configuration setting allows you to set the IPv6 connection type to access the IPv6 network.