Page 22
Installation:
System Set-up Wiring
Figure 30:
Set-up Wiring Detail
Ground Level Smart Controller Initialization
Note
Tail End Resistor (120K Ohm)
installed at output
“Signal Out (+)” to “Signal Out (-)”
Note
Four Tail End Resistors
(120K Ohm)
temporarily installed
at fl uid ports
“Port (+)” to “Port (-)”
On each output port.
Fluid Smart Controller:
Attach controllers one at a time,
initialize them, affi x an I.D. label, then
replace with the next controller and
repeat the process.
Air Smart Controller:
Remains in position through-
out the ground level set-up
process.
Queuing Console:
Attach controllers to multipin
connector on console.
Use Model
3120-xxx
Comm/Power Cables
1 to 2 foot lengths each.
Discard after setup
